Table of Contents
Advertisement
HOW TO DISABLE OPERATING MODES
The three operating modes of the KEEMUX-Sx SUN KVM switch can be disabled if a user desires to do so. The Command
Mode can be disabled which would also disable the Scan and Broadcast Modes, or, the Scan and/or Broadcast Modes can be
individually disabled leaving the other features in Command Mode enabled.
To disable these operating modes, the user must get access to the jumpers block.
switches on the circuit board the keyboards plug into (called the digital board) inside the KEEMUX-Sx.
Rear Panel
Front Panel
LED board
Overhead view of video board on top of digital board.
If the unit is a rackmount style, the digital board is located directly beneath the cover of the unit, requiring the user to only remove
the 9 screws from the cover to gain access. With the cover removed, the jumpers block will be easy to locate. Follow the
instructions under "CONFIGURING THE JUMPER BLOCK" on page 9 to disable the desired mode(s).
If the unit is in a plastic case, the digital board is located on the bottom of the case, requiring the user to partially disassemble the
unit to gain access to the jumpers block.
the procedure used if the unit does not have the OSD option.
For models KEEMUX-Sx (no OSD):
1. Make sure the KEEMUX-Sx is completely disconnected from all computer components.
unplug the KEEMUX-Sx from the electrical outlet.
2. Remove the two philips-head screws from the underside of the KEEMUX-Sx and set the KEEMUX-Sx on
a firm and flat surface, bottom down.
3. Remove the top half of the plastic case from the KEEMUX-Sx.
Video Board
Digital Board
The jumper block is located
below the LED board.
If the unit has the OSD option (KEEMUX-Sx -O), the procedure will be different than
Philips-head screws
holding the plastic case
together
View of bottom of plastic case
6
This block is located close to the dip
Closeup view of jumper block on digital board.
JUMPER BLOCK
DIP SWITCHES
S
B
K
L
C
R
C
C
A
D
M
D
N
C
D
E
Be sure to
Advertisement
Table of Contents
