Operation - Yetter TITAN Series Owner's Manual

Where rocks are present, the residue manager should be set to
float. The system can be damaged if a rigid setting is used.
Adjust the residue manager to move crop residue aside and not to move soil.
Adjustments to the residue manager may have to be made with changing field
conditions and the type and/or amount of residue. Use the handle for leverage when
changing depth settings.
Float Settings
Install the adjustment pin below the combo arm.
To raise the wheels, lift the combo arm and move the adjustment pin up.
To lower the wheels, lift the combo arm and move the adjustment pin down.
Rigid Settings
Install the adjustment pin through the combo arm.
To raise wheels, lift the combo arm to the desired position and insert the pin.
To lower wheels, lower the combo arm to the desired position and insert the pin.
Residue Manger Do's and Don'ts
1. DO NOT move soil; Residue Managers are designed to move crop residue
only.
2. DO NOT operate planter at slow speeds, ground speed affects how
aggressive the spoke wheels are. Operate at sufficient speed (4-6 mph) to
maintain good residue flow.
3. DO NOT expect 100% of crop residue to be cleared. It is not necessary and
would necessitate engaging the soil. The width of the cleared path depends
on ground conditions, depth setting, and ground speed.
4. DO expect to see wheels occasionally quit turning. This indicates ideal
(shallow) setting which is not moving soil.
5. DO adjust toolbar frame height 20"-22" and drawbar to level correctly. This is
very important to ensure planter opener will follow ground contours properly.
6

OPERATION