ABB NPBA-12 Installation And Startup Manual page 22

Chapter 5 – Programming
Table 5-1 The NPBA-12 configuration parameters.
Fieldbus
Parameter Name
Par. No.
1 MODULE TYPE
2 PROTOCOL
3 PPO TYPE
4 NODE NUMBER
5 NO. OF DATA SETS
6 DATA SET INDEX
7 CUT-OFF TIMEOUT
8 COMM PROFILE
9 CONTROL ZERO MODE
MODULE TYPE
PROTOCOL
PPO TYPE
NODE NUMBER
NO. OF DATA SETS
5-2
(Read-only)
(0) DP; (1) DPV1
(0) PPO 1; (1) PPO 2; (2) PPO 3; (3) PPO 4; (4) PPO 5
2 to 126
1 to 4
(0) FBA DSET 1; (1) FBA DSET 10
0 to 255
(0) ABB DRIVES; (1) CSA 2.8/3.0
(0) STOP; (1) FREEZE
This parameter shows the module type and software version as
detected by the drive. The value cannot be adjusted by the user.
If this parameter is undefined, the communication between the drive
and the module has not been established.
This parameter selects the protocol used.
DP
This setting can be used with PROFIBUS masters that support the DP
or DPV1 protocol.
DPV1
This setting must be used with DPV1-only PROFIBUS masters.
This parameter selects the PPO message type for the PROFIBUS
connection. See Figure 6-1
Each device on the PROFIBUS link must have a unique node number.
This parameter is used to define a node number for the drive it is
connected to.
This parameter defines the number of data sets sent in each direction
in PPO messages; e.g.. if this parameter is set to 1, only data sets 1
(master to drive) and 2 (drive to master) are used. Setting this
parameter to 4 enables all eight data sets shown in
sets with odd numbers (1,3,5,7) are sent by the master to the drive and
those with even numbers (2,4,6,8) are sent by the drive to the master
(providing DATA SET INDEX is set to FBA DSET 1). Please note that
different drive types support different numbers of data sets; see the
drive documentation.
Alternative Settings
for available PPO message types.
NPBA-12 Installation and Start-up Guide
Default
Setting
NPBA-12 Vx.x
(0) DP
(0) PPO 1
2
1
(0) FBA DSET 1
30
(0) ABB DRIVES
(0) STOP
Figure 6-1: data