Suzuki Super Swift Owner's Manual page 420

INSPECTION AND MAINTENANCE
EXAMPLE
(2)
(3)
(4)
(1)
68PM00721
(3) Removal
(4) Installation
2) To remove the bulb of the front turn sig-
nal light (1) from the bulb holder, push
in the bulb and turn it counterclockwise.
To install a new bulb, push it in and turn
it clockwise.
To remove and install the bulb of the
front position light (2), simply pull out or
push in the bulb.
7-41
Side turn signal light
Outside rearview mirror type
LED is used. It is recommended that you
take your vehicle to an authorized SUZUKI
dealer for bulb replacement since special
procedures are required.
Fender type
Since the bulb is built-in type, replace it as
the light assembly. Remove the light
assembly by sliding the light housing left-
ward with your finger.
Front fog light (if equipped)
1) Start the engine. Turn the steering
wheel to the opposite side of the fog
light to be replaced to replace the bulb
easily. Then turn off the engine.
EXAMPLE
(1)
(2)
2) Remove the clip (1) and screws (2) at
64J195
the bottom of bumper.
For removing the clip, use a flat blade
screwdriver as show in the illustration.
52RM70150
52RM0-01E