Suzuki Super Swift Owner's Manual page 407

EXAMPLE
52RM70500
WARNING
If you experience any of the following
problems with your vehicle's brake
system, have the vehicle inspected
immediately by an authorized
SUZUKI dealer.
• Poor braking performance
• Uneven braking (brakes not work-
ing uniformly on all wheels.)
• Excessive pedal travel
• Brake dragging
• Excessive noise
Parking brake
EXAMPLE
Ratchet tooth specification "b":
4th – 9th
Lever pull force (1):
200 N (20 kg, 45 lbs)
Check the parking brake for proper adjust-
ment by counting the number of clicks
made by the ratchet teeth as you slowly
pull up on the parking brake lever to the
point of full engagement. The parking
brake lever should stop between the speci-
fied ratchet teeth and the rear wheels
should be securely locked. If the parking
brake is not properly adjusted or the
brakes drag is suspected even after the
lever has been fully released, have the
parking brake inspected and/or adjusted by
an authorized SUZUKI dealer.
INSPECTION AND MAINTENANCE
Brake discs and brake drums
Brake disc
Brake location Minimum thickness
Front wheels 18.0 mm (0.7 in.)
Rear wheels
8.0 mm (0.3 in.)
(if equipped)
Brake drum
Maximum inner
Brake location
diameter
2WD
Rear wheels
54G109
(if equipped)
4WD
If the measured thickness or inner diame-
ter of the most worn part falls below or
exceeds the value indicated above, the
parts should be replaced with a new one.
The measurement involves disassembling
each brake and requires the use of a
micrometer or caliper, which must be done
according to the instructions described in
the relevant service manual or available
from the relevant repair information site.
181 mm
(7.13 in.)
222 mm
(8.74 in.)
7-28
52RM0-01E