Suzuki Super Swift Owner's Manual page 151

play to tell you it is necessary to change
the engine oil and oil filter. When the
engine oil and oil filter are changed and the
oil life monitoring system is reset, this light
will go out. For details of the maintenance
schedule, refer to "Periodic maintenance
schedule" in "INSPECTION AND MAINTE-
NANCE" section.
Whenever the engine oil and oil filter are
changed, the light must be reset to monitor
the next oil change timing properly. The
light will go out after the reset. For the
resetting procedure, refer to "Information
display" in this section.
NOTICE
Severe engine damage will result, if
you keep operating the engine after
this light comes on.
Change the engine oil and oil filter
immediately when the light blinks.
NOTE:
• This light is used to facilitate the oil and
oil filter change according to the mainte-
nance schedule.
• Even though the oil is replaced before
this light comes on, reset of the oil life
monitoring system is necessary. Consult
an authorized SUZUKI dealer about the
reset method. If you reset it by yourself,
refer to "Setting mode" in this section.
• Consult an authorized SUZUKI dealer
for changing the setting of oil life moni-
toring system in one of the following
cases;
– If you replace ACEA Standards or
SUZUKI genuine engine oil by the
engine oil other than ACEA Standards
or SUZUKI genuine engine oil, or vice
versa
– By the change of your driving condi-
tion, if you need to apply the schedule
of "Maintenance recommended under
severe driving conditions" instead of
"Periodic maintenance schedule" in
"INSPECTION AND MAINTENANCE"
section, or vice versa
ENG A-STOP indicator light
(if equipped)
72M00032
When the ignition switch is turned to "ON"
position or the engine switch is pressed to
change the ignition mode to ON, this light
comes on briefly so you can check that the
light is working.
When the engine stops automatically, this
light comes on.
BEFORE DRIVING
For details, refer to "ENG A-STOP system
(engine auto stop start system)
equipped)" in "OPERATING YOUR VEHI-
CLE" section.
ENG A-STOP OFF light (if equipped)
72M00159
When the ignition switch is turned to "ON"
position or the engine switch is pressed to
change the ignition mode to ON, this light
comes on briefly so you can check that the
light is working.
When you push the ENG A-STOP OFF
switch, this light comes on.
This light blinks in either of the following
cases.
• There may be something wrong with the
ENG A-STOP OFF system.
• It may be time to replace the battery.
You should have the system inspected by
an authorized SUZUKI dealer.
For details, refer to "ENG A-STOP system
(engine auto stop start system)
equipped)" in "OPERATING YOUR VEHI-
CLE" section.
2-132
52RM0-01E
(if
(if