H3C SecPath M9000 Series Installation, Quick Start page 6

The M9010 has two cable management brackets—the signal cable management brackets are
•
installed at the upper part of the gateway, and the power cable management brackets are installed
at the lower part of the gateway. They are installed in the same way. For more information,
see Figure 3.
• The power cable management bracket installation procedure for the M9014 is the same as M9010.
The power cable management brackets of the M9006 have a slightly different structure, and
•
installed in a similar procedure. For more information, see
To install a cable management bracket:
1. Unpack the cable management brackets.
2. Attach the cable management bracket to the chassis, and align the screws with the mounting holes
on the chassis, as shown in
3. Fasten the screws.
Figure 3 Attaching cable management brackets to an M9010
(1) Attach the cable management bracket to the chassis
(2) Screw holes for installing the cable management bracket
(3) Screws for attaching the cable management bracket to the chassis
(4) Signal cable management bracket (installed at the upper part of the chassis)
(5) Power cable management bracket (installed at the lower part of the chassis)
Figure 3.
1
1
3
Figure 4.
2
4
2
5
3
3