Step 4: Connect Power To The Acx5096 Router; Connect Ac Power To An Ac-Powered Acx5096 Router - Juniper ACX5096 Quick Start Manual

9

Step 4: Connect Power to the ACX5096 Router

IN THIS SECTION

Connect AC Power to an AC-Powered ACX5096 Router | 9

Connect DC Power to an DC-Powered ACX5096 Router | 10
Depending on your configuration, your router uses either AC or DC power supplies. Perform the appropriate
procedures for each power supply in your router.
The power supply in an ACX5096 router is a hot-removable and hot-insertable field-replaceable unit (FRU).
You can remove and replace it without powering off the router or disrupting router functions.
WARNING: You must ground the router before connecting the power cables.
Connect AC Power to an AC-Powered ACX5096 Router
The ACX5096 router is supplied with two factory-installed power supplies.
To connect power to an AC-powered router:
1. Attach the grounding strap to your bare wrist and to a site ESD point.
2. If the AC power source outlet has a power router, set it to the off (0) position.
3. Insert the coupler end of the power cord into the AC power cord inlet on the AC power supply faceplate.
4. Push the power cord retainer onto the power cord.
5. Insert the power cord plug into the power source outlet.