Assembling A Single Pylon; Assembling A Double Pylon - Lionel Pylon Owner's Manual

Assembling a single pylon

C
omplete the assembly of your Pylon by attaching the included figure and support rod to
the structure. Figure 1a illustrates the following procedure.
1. Note that the supporting rod has different shaped ends. Insert the D-shaped coupling bot-
tom end of the support rod onto the D-shaped mounting post on the top of the pylon. Refer
to the diagram for further assistance.
2. Insert the D-shaped top end of the rod into the D-shaped opening in the bottom of the fig-
ure.
D-shaped mounting
post on top of pylon
Figure 1a. Installing the support rods on a single pylon

Assembling a double pylon

C
omplete the assembly of your double pylon by attaching the included figures and their
support rods to the structure. Figure 1b illustrates the following procedure.
1. Note that the supporting rods have different shaped ends. Insert the flattened ends of the
support rods into the tubes protruding from the top of the pylon. Refer to the diagram for
further assistance.
2.Insert the D-shaped ends of the wires into the openings in the bottom of the figures.
Once your accessory is wired, the base is secured, and the figures are attached, you are
clear for takeoff!
Figure 1b. Installing the support rods on a double pylon
D-shaped coupling sup-
port rod (bottom)
u r e
f i g
o f
a r
R e
f i g
o f
n t
F r o
u r e
4
D-shaped mount-
ing hole, bottom of
figure
D-shaped
support rod (top)