Table of Contents
Advertisement
Conventional transformer operations
Locking your locomotive into a single direction
W
hen the Command reverse unit switch is in the RUN position, your locomotive sequences
through a repeating pattern of operations: forward, neutral, reverse, neutral, and so on.
To "lock" your locomotive into a single direction (for example, to operate in forward only),
you can deactivate the Command reverse unit's sequencing function.
1. Use your transformer's DIRECTION button or interruptions in track power to
get your locomotive moving slowly in the desired direction or into neutral.
2. Slide the Command reverse unit switch to the PROG position. At this point, the
locomotive is "locked" into your chosen direction. See Figure 6 on page 8 for the
location of this switch.
To restore the forward-neutral-reverse sequence, just slide the Command reverse unit
switch back to the RUN position.
Note!
Because of the way that speed control operates in conventional mode, you will
notice a slight delay between adjusting your transformer throttle and the change in
the speed of your locomotive.
Reprogramming your locomotive to restore features
I
f your LionChief Plus 2.0 locomotive is unresponsive to your commands in the Command Control
environment, we recommend that you follow this procedure to reset your locomotive. All factory
default settings will be restored when you reprogram the locomotive.
1. Slide the program run switch to the PROG position.
2. Plug in and connect your LEGACY Base.
3. Place your locomotive on the track, then power up the track.
4. Press ENG and enter the locomotive's ID#.
5. Press SET.
6. Press and hold Reset or AUX1, 0 until you hear a single bell ding.
7. Slide the program run switch back to the RUN position.
At this point, your LionChief Plus 2.0 locomotive has been reset. Restore power to the track
and operate the locomotive as usual. Be sure to use the ID# entered in Step 4.
32
Advertisement
Table of Contents
