Mounting The Tool - JEI MAGBEAST HM140T Safety Instructions And Operator's Manual

Plug the power cable in to a suitable power supply (using extension lead of the correct rating if
necessary) The use of an RCD is also highly recommended.
b) Drilling – Broaching
Energise the magnet by switching on the magnet switch
Check the magnet is holding to the work piece. Using the oil bottle add oil to the work piece. If
cutting in inverted position it is recommended an aerosol foam coolant or cutting paste is used.
Select the required speed. Do NOT attempt to change speed while the machine is drilling.
Start Motor
Please note that the motor will not run unless the magnet is energised.
If for any reason the power is interrupted the relay makes it necessary to restart the motor
again before cutting can continue.
Advance the cutter to the work piece using light and controlled pressure until the cutter has
broken the surface, then increase pressure until the motor is loaded. Maintain even pressure
right through the cut.
Too much pressure will NOT speed up the cut, it will reduce the life of the cutter and may cause
damage to the motor.
If the turnings become blue add more oil. At the end of the cut the slug will be ejected, check
before commencing next hole.
Stop motor, switch off magnet.
WARNING:
Under no circumstances try to remove turnings or swarf from the cutter when
machine is in operation. NEVER introduce and body parts to moving parts of the machine when it is
switched on.
This document is issued for general information and instruction and as such does not constitute a
specification of the equipment.
Only use faultless and sharp drilling tools and avoid that the machine stops due to overload.

MOUNTING THE TOOL

DISCONNECT THE PLUG FROM THE MAINS BEFORE EVERY TOOL CHANGE!
8 | P a g e