Table of Contents
Advertisement
The indication of noise emission is measured according to DIN 45 635, part 21. Level of acoustic
pressure on the work place could exceed 85 dB (A) in this case protection measures must be taken.
WEAR EAR PROTECTORS!
The typical hand arm vibration is now below 2.5m/s 2
Measured values determined according to EN 50 144
The declared vibration emission level represents the main applications of the tool. However if the
tool is used for different applications with different accessories or poorly maintained the vibration
emission may differ. This may significantly increase the exposure level over the total working
period.
SAFETY CLUTCH
The safety clutch should absorb shock and excessive stress. It is an aid and not an absolute
protection. Therefore you have to handle and drill carefully.
To keep in good condition the clutch should slip for a very short time (max 2 seconds) in each case
only.
After excessive wearing the clutch has to be renewed by an authorised service shop.
Always ensure that the motor is fully stopped before attempting to change the speed of the
machine.
OPERATING THE MACHINE
a)
Fitting the cutter or drills
Always unplug the power source to the machine before fitting or removing cutters or drills into
the arbour. To fit cutters loosen both screws to permit the cutter shank to fit fully into the
arbour ensuring the flats of the cutter are in line with set screws, then tighten the set screws
until the cutter is safely locked in to the arbour.
With a gloved hand or a brush clean any dirt or swarf from the base of the magnet and the work
piece and place unit in correct place for drilling.
Attach safety chain by looping it through the handle of the machine and around the work piece
or other suitable anchor point. Take up any slack on the chain and clip the hook through a
convenient link in the chain.
7 |
P a g e
Advertisement
Table of Contents
