Mounting Of Cutters - JEI MAGBEAST HM200T Operator's Manual

lengths shall not be exceeded:
For 110v supply:
For 230v supply:
ALWAYS DISCONNECT THE MACHINE FROM THE POWER SOURCE WHEN CHANGING CUTTERS.

[5] MOUNTING OF CUTTERS

The machine has been made to accept MT5 Arbor.
The following procedure is to be used when mounting cutters.
- Take appropriate pilot and place through hole in shank of cutter.
- Insert shank of cutter into 1 1/4" bore of arbor, ensuring alignment of two drive flats with socket
screws.
- Tighten both screws using hexagon key.
6 | P a g e
3.5metres of 3 core x 1.5mm²
26metres of 3 core x 1.5mm² or
17metres of 3 core x 1.0mm²
MAGBEAST HM200T