Siemens HB 151.50 B Instruction Manual page 26

Cleaning the oven floor and
the side walls
Cleaning the glass cover
for the oven light
26
All manuals and user guides at all-guides.com
If splashes are still visible even after repeated use,
proceed as follows:
First clean the enamel surfaces in the oven. Then
select 3D hot air T or top and bottom heating t.
Heat up the empty oven for approximately 2 hours at
maximum temperature.
The ceramic coating is regenerated.
Brownish or whitish residues can be removed with
water and a soft sponge.
Light discolouration of the coating does not affect
automatic self cleaning.
Important notes
Never use abrasive detergent. You will scratch or
destroy the highly porous coating.
Never clean the ceramic coating with oven cleaner.
If oven cleaner accidentally gets onto the rear panel or
roof of the oven, remove it immediately with a sponge
and plenty of water.
Use hot soapy water or a vinegar solution.
It is best to use oven cleaner if the oven is very dirty.
Only use oven cleaner in a cold oven.
Never use oven cleaner on the self cleaning surfaces
of the oven.
Note:
Enamel is baked on at very high temperatures. This
can cause some slight colour variation. This is normal
and does not affect the function. Do not use coarse
scouring pads or strong cleaning agents to remove
such discolorations.
The edges of thin trays cannot be completely
enamelled. As a result, these edges can be rough.
Anti corrosion protection is guaranteed.
It is best to clean the glass cover with washing up
liquid.