Connection Of Control Interfaces And Terminals; X5, Motor And Mains Connections - Bosch Rexroth EcoDrive 03 Instruction Manual

5-6
Instructions for Use

Connection of Control Interfaces and Terminals

X5, Motor and Mains Connections

Illustration:
Connection cross section:
See Project Planning Manual for more details.
DANGER
Technical description of connector
Fig. 5-11: Connector X5
Note:
• To pull off the connectors, loosen the barbs.
• The maximum number of insertion/withdrawal cycles is
Design:
Type
connection block
Fig. 5-12: Design
Cross section
single wire
[mm²]
1,5
Fig. 5-13: Connection cross section
Rexroth EcoDrive 03 DKC**.3-016
Lethal electric shock caused by live parts with
more than 50 V!
⇒ Before working on the drive controller, switch off the
power supply via the main switch or the fuse.
⇒ Always mount or dismount both connectors (motor
connector and mains connector) on the drive
controller at the same time.
⇒ Connect the protective conductor connections XE1
and XE2 to the protective conductor system of the
control cabinet. Check the continuity of the protective
conductors from the mains connection to the
connected motors.
Observe information in chapter "Important Notes"
⇒
barbs
limited to 15.
No. of pins
2 x 3
max. connectable
cross section
[mm²]
1,5
Ap5402f1.fh7
Design
bushing on connector
max. Wire size
in AWG
gauge no.:
16
DOK-ECODR3-DKC16*UL***-IB01-EN-P