Table of Contents
Advertisement
32/65
Bosch Rexroth AG
Mounting, Dismounting and Electrical Installation
A
Fig.10-13:
Latching the terminal on top-hat rail
Ensure that all feather keys and keyways of neighboring terminals
are interlocked (B in 10-13).
The keyway/feather key connection connects neighboring modules to
each other. After the terminal has been latched on the top-hat rail, con‐
tinue as follows:
3.
Fit the connectors onto the respective terminal.
C
Fig.10-14:
Fastening the connectors
4.
First fit the front connector shaft latch in the front release mechanism (C
in 10-14).
5.
Press the connector towards the terminal until it clicks into place in the
rear release mechanism (D in 10-14).
The keyways provided in the terminal are not continued in the
connector. A terminal can only be latched on, if there is no con‐
nector to the left of it. If necessary, the connector has to be re‐
moved.
Once the station has been set up, individual terminals can be replaced
subsequently by being pulled out or plugged in without any additional
tools.
Mounting step: Mounting the EMI shielding
1.
The shielding must form the mechanical termination to the right of the
control, irrespective of whether Rexroth Inline terminals have been
mounted in series or not.
DOK-CONTRL-IC*LX5*****-IT01-EN-P
Rexroth IndraControl L25, L45, L65 and L85 Controls
B
D
Hide quick links:
Advertisement
Table of Contents
