Mounting The Fan (If Necessary); Dismounting The Control - Bosch Rexroth IndraControl L25 Instruction Manual

34/65 Bosch Rexroth AG
Mounting, Dismounting and Electrical Installation
10.4

Mounting the Fan (if Necessary)

10.5

Dismounting the Control

Necessary tools
Dismounting steps
1
2
① Control bottom side
② Fan
Fig.10-16: Mounting the fan
1. Put the fan ② onto the control ①, see 10-16.
2. Latch in the fan by exerting slight pressure.
● Screwdriver
Dismounting step: Separating function modules from the control (if
function modules have been mounted)
1. Remove the left end clamp first.
2. Slide the function modules along the top-hat rail to the left until the plug
connection of the PCI
Dismounting step: Removing the first Rexroth Inline terminal (if Inline
terminals have been mounted)
1. Start with the first Inline terminal that is mounted to the right of the con‐
trol.
All connectors of the terminal must be removed.
2. Remove the labeling field, if present (A1 in 10-17).
3. Pry out the connector of the terminal to be removed by pressing on the
rear connector shaft latch (A2 in 10-17).
DOK-CONTRL-IC*LX5*****-IT01-EN-P
Rexroth IndraControl L25, L45, L65 and L85 Controls
PLUS bus is separated.