Bosch Rexroth IndraControl L25 Instruction Manual page 52

50/65 Bosch Rexroth AG
Device Description
Reset button and stop LED on the
control
LED on the control
Display elements on the modules
and voltage supply connector
Key Menu navigation
<Up> One menu entry up
(up arrow)
<Enter> One level down
Fig.12-3: Functions of the operating keys
The reset button and a red LED are arranged in the section below the dis‐
play.
Fig.12-4: Reset button and stop LED
Reset button
Press the reset button (> 2 seconds). This resets the whole de‐
vice and a restart is forced, without the need to switch off the sup‐
ply voltages.
The reset button can only be actuated with a sharp tool (e. g. a tip of a pen‐
cil).
The LED serves for diagnostic display and status display.
The device states displayed are firmware-dependent and are described in the
relevant system description.
Depending on the connected modules, further display elements are available
in addition to the display elements on the control. For details, please refer to
the relevant instructions of the modules.
DOK-CONTRL-IC*LX5*****-IT01-EN-P
Rexroth IndraControl L25, L45, L65 and L85 Controls
Input functions
Increase parameter value
Confirm input