Operating Instructions - Flex L602VRH Operating Instructions Manual

Polisher L602VRH/VRB
Attaching or changing the tool
holder
1. Pull out the mains plug.
2. Press and hold down the spindle lock.
3. Screw the tool holder (Velcro pad,
backed fleece, sanding pad) clockwise
onto the spindle and tighten hand-tight.
4. Attach the tool to the tool holder.
5. Insert the mains plug into the socket.
6. Switch on the polisher (without engaging
it) and run the polisher for approx.
30 seconds. Check for imbalances and
vibrations.
7. Switch off the polisher.
To remove the chuck:
1. Pull out the mains plug.
2. Press and hold down the spindle lock.
3. Unscrew the chuck (Velcro pad, fleece
pad, sanding pad) anti-clockwise off the
spindle.
Attaching the tools
Attention!
Attach the tools in the centre of the tool
holder. Imbalances may damage the power
tool. The work result may be impaired.
– Use the centring aids.

Operating instructions

Note
When the machine is switched off,
the grinding tool continues running briefly.
– If using a polishing paste, use the
respective tool for each paste.
– On sensitive surfaces (e.g. car
paintwork) do not work aggressively
but work at slow speeds applying low
contact pressure.
– Sponges can be washed in the washing
machine.
For further information on the
manufacturer's products go to
www.flex-tools.de.
17