Maintenance And Care - Flex L602VRH Operating Instructions Manual

Maintenance and care

Danger!
Before carrying out any work on the
polisher, always pull out the mains plug.
Cleaning
Danger!
If metals are ground or cut over a prolonged
period, conductive dust may become
deposited inside the housing.
Impairment of the protective insulation!
Operate the power tool via a residual-
current-operated circuit-breaker
(tripping current 30 mA).
Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
dependent on the material and duration of
use.
Regularly blow out the housing interior
and motor with dry compressed air.
Carbon brushes
The polisher features cut-off carbon
brushes.
When the wear limit of the cut-off carbon
brushes is reached, the polisher switches
off automatically.
Note!
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
When the polisher is being used, the carbon
brushes can be seen sparking through the
rear air inlet apertures.
18
If the carbon brushes spark excessively,
switch off the polisher immediately. Take the
polisher to a customer service workshop
authorised by the manufacturer.
Gears
Note!
Do not loosen the screws on the gear head
(3b) during the warranty period. Non-
compliance will deem the guarantee
obligations of the manufacturer null and
void.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
Spare-part/Accessory
Side handle
Handle cover
Bail handle
2 screws for bail handle
Velcro pad 160 mm with
centring tube
Velcro sponge, Ø 200x40 mm
Velcro wool pad, Ø 200 mm
For other accessories, in particular tools
and polishing aids, see the manufacturer's
catalogues.
Polisher L 602VRH/VRB
Order
no.
252.721
259.508
287.709
251.614
252.583
304.778
252.278