Table of Contents
Advertisement
6:1 Front seat height
The front seat height (settable
43-52.5 cm) is dependent on:
5", 6" or 6.5".
Front fork attachment Settable in angle.
Front fork: Short or medium with
three alternative height settings for
the castor.
Risk of tipping: Always check
the positioning of the anti-tips.
6:2 Castor wheel
The height may be adjusted by chang-
ing the castor wheel itself or by chang-
ing its position in the fork. Unscrew
the castor wheel and place it at the
desired height in the front fork.
Tools: 5 mm Allen key and
10 mm U-spanner.
6:3 Changing front fork
Unscrew the protective stopper (1)
on the front fork attachment to
reach the retaining nut (2). Unscrew
the nut and pull out the front fork.
Take the washer from around the
fork axle and put it on the new fork
(the bevelled side (A)) towards the
fork). Insert the new fork into the
attachment. It is also important
to ensure that the washers in the
attachment (under the retaining
nut) are placed in the right order,
with the spring washer (B) on top.
Tighten the retaining nut until it
cannot be turned any more. Loosen
it 1/2-1 turn. The spring washer
then has the correct tension. It re-
duces the risk of the castor starting
to "wobble".
6 Settings seat
(!) See also point 13:
"Alternative seat heights/angles".
(!) Also adjust the angle of
the front fork attachment,
see point 6:4.
Tools: 19 mm socket spanner.
(!)
Also adjust the angle of the
front fork attachment, see
point 6:4.
10
1
B
2
Bearings
A
Advertisement
Table of Contents
