Transportation In Vehicles - Etac Transit Manual

Etac's wheelchairs are tested in accordance with ISO
7176-19 (see "Tests and guarantees" section in the
manual).
Etac recommends in the following order:
1) The user transfers to a seat in the vehicle and uses the
vehicle's 3-point belt while travelling. The wheelchair
is then placed in the boot or safely in the back seat so
that it cannot overturn or roll.
2) The wheelchair is secured facing forwards in the vehicle
as per this manual, the user uses a separate 3-point
belt that is secured in the vehicle. This is the way in
which the wheelchair is tested and approved.
Securing
•
Securement points rear must be used.
•
Restraining device must not be put through the wheels
or around the back tubes.
3) According to directive 2001/85/EC, appendix VII, point
3.8.3. there are specially marked wheelchair locations
in vehicles that permit transport with a wheelchair
facing in the opposite direction of travel. If this means
of travel is used, the user/carer must be aware while
travelling, prepared for sudden movements and have
the capacity to maintain a safe sitting position throug-
hout the entire journey. The user's disabilities must not
be of such an extent that he/she is not able to hold
onto the handles fitted in the vehicle when there are
changes of speed or direction.
User manual

Transportation in vehicles

11
Etac / Transit / www.etac.com
•
If possible, the wheelchair should be placed in the
boot.
•
If the wheelchair is placed in the back seat, make
sure it can not overturn or roll. If possible secure the
wheelchair with the car's safety belt.
•
The parking brake must be used.
•
The anti-tips must be lowered.
•
Accessories/parts that can be removed without tools,
shall be removed and secured.
•
A correctly adjusted head support shall be used.
•
The backrest shall be level with or above the user's
shoulders.
•
Cross brace must be used.
•
The parking brake must be used.
•
The anti-tips must be lowered.
•
Accessories/parts that can be removed without tools,
shall be removed and secured.
•
A correctly adjusted head support shall be used.
•
The backrest shall be level with or above the user's
shoulders.
•
Positioning belt must be used.