U-Line H-35 Manual page 3

3. Insert the tank into the opening on the front of the
machine, making sure the tank is behind the upward
lip on the tank shelf.
4. Fill the bottle with water and place in the bottle
holder so that the spout of the bottle is in the tank.
5. Adjust the roll guides for proper width of tape.
6. To load tape, take the roll of tape and peel off about
18 inches. Place the roll of tape in the basket so that
the strip of tape unwinds off the rear of the roll as
the leading end is brought towards the front of the
machine with the gummed side down. Thread the
tape over the black roller at the upper rear and slide
leading edge forward under the upper tape plate
and feed wheel. Close front and rear covers.
(See Figures 7a and 7b)
Figure 7a
Figure 7b
Black Roller
Tape
ADJUSTMENTS
TAPE WIDTH
The adjustable roll guides in the tape basket should be
properly set for the width of tape being dispensed. The
roll of tape should be centered between the frames
by threading the tape loosely between the roll guides,
which engage in slots in the basket and roll guide
separator.
To set the roll guides in position, lift them out of the slots in
the basket and tie rod. Slide to the desired position and
drop guides into slots in the bottom of the basket.
(See Figure 8)
PAGE 3 OF 15
SETUP CONTINUED
WATER LEVEL ADJUSTMENT
The amount of water required for proper moistening
of different grades of tape will differ. Heavier glues
or reinforced tapes will normally require higher levels
of water. Water level is controlled by the water level
adjustment screw located in the projecting portion of the
water tank. (See Figure 9)
To raise the water level, turn the screw counterclockwise.
To decrease the water level, turn the screw clockwise.
REPEAT LENGTH STOP
The Better Pack 333 Plus is equipped with a feed stop. To
set for desired length, pull outwardly on the feed stop
until the pin disengages the hole in the drum skirt. Then
slide the feed stop assembly until the length desired
is set on the scale just above the feed stop assembly.
Release the knob, being sure the pin on the feed stop
engages with the proper hole in the skirt. (See Figure 10)
Figure 8
Slots
Figure 10
Roll Guide
Figure 9
Water Level
Adjustment
Screw
Drum
Skirt
Hole
Feed
Stop
0614 IH-35