Connecting To Mains Supply - Goodmans 4212 Instruction Manual

C
ONNECTING TO
This appliance may be fitted with a non-rewireable plug. If it is necessary to change
the fuse in a non-rewireable plug the fuse cover must be refitted. If the fuse cover
is lost or damaged, the plug must not be used until a replacement available from the
appliancemanufacturer is obtained. It is important that the colour of the replacement
fuse cover corresponds with the colour marking on the base of the plug.
If the plug has to be changed because it is not suitable for your socket, or becomes
damaged, it should be cut off and an appropriate plug fitted following the wiring
instructions below. The plug removed must be disposed of safely as insertion into a
13A socket is likely to cause an electrical hazard.
For your own safety read the following instructions carefully before attempting to
connect this unit to the mains.
M (AC) O
AINS PERATION
This unit is designed to operate on 230 V, 50 Hz current only. Connecting it to
other power sources may damage the unit
The wires in this mains lead are coloured in accordance with the following code :
BLUE = NEUTRAL BROWN = LIVE
I
MPORTANT
As the colours of the wires in the mains lead of this appliance may not correspond
with the coloured markings identifying the terminals in your plug, proceed as
If a 13 Amp (BS 1363) Plug is used, a 3 Amp Fuse must be fitted, or if any other type of
Plug is used a 3 Amp Fuse must be fitted, either in the Plug , or on the Distribution Board.
C
AUTION
To prevent electric shock disconnect from the mains before removing cover. No
user serviceable parts inside. Refer servicing to qualified service personnel.
S P
AFETY RECAUTION
Do not allow this unit to be exposed to rain or moisture.
Mains Supply:
This symbol means that this unit is double insulated. An earth connection is not
required.
CAUTION
CLASS 1 LASER PRODUCT
Use of Controls or adjustments or performance of
procedures other than those specified herein may
result hazardous radiation exposure.
CAUTION
CLEANING: Always disconnect unit from mains supply before attempting to clean it. Use soft cloth
moistened with soapy water, wipe gently. Do not use solvents or abrasive materials.
M
AINS
follows:-
The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
No connection is to be made to the earth terminal of
plug.
230 Volts 50 Hz - AC only.
LASER SAFETY
This unit employs a laser, only qualified service
- 2 -
S
UPPLY
personnel should attempt repair.
DANGER: INVISIBLE LASER RADIATION
WHEN OPEN AND INTERLOCK FAILED
OR DEFEATED. AVOID DIRECT
EXPOSURE TO BEAM.
CAUTION: HAZARDOUS
RADIATION WHEN
INTERLOCK DEFEATED.
the
LASER
OPEN AND