Goodmans 4212 Instruction Manual page 9

T
O PLAY Y O U R P R O G R A M M E D TRACKS
m
Press Play/Pause on the unit or the remote control.
m
Please Note:
m
If play/pause is pressed before the prog button is pressed to store a track, the track
will not be stored into the memory, and the disc will start playing from the first
programmed track.
C
L E A R I N G A P R O G R A M M E D M E M O R Y
During play, press Stop twice.
Please Note:
Selecting a different playing mode, turning the power OFF or pressing STOP during a
programmed play mode erases the programmed order of tracks.
R D P
EPEAT I S C LAY
m
To repeat all 3 discs.
m Press the Repeat button once. The display will show Repeat All Disc. Press the
Play/Pause button.
m
The discs will play continuously until Stop is pressed or the Repeat button is
pressed until "Repeat All Disc" disappears from the display.
m To repeat one disc, press the Repeat button until the display shows Repeat One
Disc.
m
Press Play/pause The entire disc will play continuously until you press Stop or
press the Repeat button until "Repeat One Disc" disappears from the display.
m To play a single track, press the Repeat button until the display shows Repeat
One. Select the track you want. Press Play and the track will play continuously
until you press Stop or press the Repeat button until "Repeat One" disappears from
the display.
T
O REPEAT A P R O G R A M M E D S E L E C T I O N
m
Select your tracks as shown on page 7.
m
Press the Repeat button once.
m
Press Play. The programmed tracks will play continuously until the Stop button is
pressed or the repeat function is cancelled.
I
NTRO
m
To select, press the Intro button on the remote control. Intro will play 10 seconds of
each track on the CD.
m
If you want to listen to a track all the way through press the Intro button again
before the end of the 10 seconds and the track will continue to play.
Please Note:
- Intro can be selected at anytime when the CD player is in use.
- Should the unit fail to operate as described above, please carry out the following
instructions.
- Unplug the unit from the mains power supply.
- Press the reset button (located on the rear of the unit) for a few seconds.
Plug the unit back into the mains power supply.
Press the Standby button on the front of the unit.
- 8 -