Using The Cd - Goodmans 4212 Instruction Manual

m
Unplug the unit from the mains power supply.
m
Press the reset button (located on the rear of the unit) for a few seconds.
m
Plug the unit back into the mains power supply.
m
Press the Standby button on the front of the unit.
U
SING THE
IMPORTANT
Since movement of the CD mechanism and the sensitive circuitry may cause interference
to a radio tuner nearby, switch this unit off while operating other radio devices.
This product utilises a laser.
Avoid direct exposure to the beam.
Caution - Use of controls, adjustments, or procedures not listed in this manual may result
in hazardous radiation exposure.
LOADING AND UNLOADING CD DISCS
m
Press the Standby button to turn the unit ON.
m
Press the CD button on the front of the unit or the Disc skip CD on the remote control.
m
Press the Open/close button to open the CD drawer.
m
When the disc drawer has opened, remove a CD from its case and place it carefully
in one of the indentations in the tray in the drawer with the label side uppermost.
m
To load more discs press the Disc skip button on the remote control to rotate the
tray. The tray will hold up to 3 CDs.
m
Press Open/close to close the drawer.
m
The unit will go through a check of the tray contents. This may take up to 30 seconds.
Please note:
• Do not put anything except a compact disc into the compartment. Foreign objects
can damage the mechanism.
• Keep the disc compartment closed when not in use to prevent dirt and dust from
entering the mechanism.
• If the disc is correctly loaded, the total number of tracks on the disc will be displayed.
• After the disc compartment is fully closed, the disc information may not appear on
the display. This means that the disc is improperly loaded (most likely it is upside
down). To check, open the disc compartment again and reload the disc.
• If the disc is inserted incorrectly, or the disc is damaged the display will show ] No disc ^ .
PLAYING CDS
Insert one or more CD discs. The display will show the number of the disc in play with a
circle round it and the total number of tracks and total play time. Press the Play/Pause
button on front panel or Play/pause on the remote control. Disc play will begin from the
start of the first track of the disc. The number of the disc that is playing will flash. The
track number and playing time will be displayed.
CD
PLAYER
- 6 -