Connecting To Mains Supply - Goodmans 4225MP3 Instruction Manual

This appliance may be fitted with a non-rewireable plug. If it is necessary to change the fuse in a non-
rewireable plug the fuse cover must be refitted. If the fuse cover is lost or damaged, the plug must not
be used until a replacement available from the appliance manufacturer is obtained. It is important that
the colour of the replacement fuse cover corresponds with the colour marking on the base of the plug.
If the plug has to be changed because it is not suitable for your socket, or becomes damaged, it
should be cut off and an appropriate plug fitted following the wiring instructions below. The plug
removed must be disposed of safely as insertion into a 13A socket is likely to cause an electrical
hazard.
For your own safety read the following instructions carefully before attempting to connect this unit to
the mains.
MAINS (AC) OPERATION
This unit is designed to operate on 230 V, 50 Hz current only. Connecting it to other power sources
may damage the unit
The wires in this mains lead are coloured in accordance with the following code :
BLUE = NEUTRAL BROWN = LIVE
IMPORTANT
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:-
BLUE
(Neutral)
CAUTION
To prevent electric shock disconnect from the mains before removing cover. No user serviceable parts
inside. Refer servicing to qualified service personnel.
SAFETY PRECAUTION
Do not allow this unit to be exposed to rain or moisture.
Mains Supply: 230 Volts 50 Hz - AC only.
This symbol means that this unit is double insulated. An earth connection is not required.
CAUTION
CLASS 1 LASER PRODUCT
Use of Controls or adjustments or performance of procedures other than those specified herein may
result hazardous radiation exposure.

CONNECTING TO MAINS SUPPLY

The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured
black.
FUSE
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
No connection is to be made to the earth terminal of
the plug.
If a 13 Amp (BS 1363) Plug is used, a 3 Amp Fuse must
BROWN
be fitted, or if any other type of Plug is used a 3 Amp Fuse
(Live)
must be fitted, either in the Plug , or on the Distribution Board.
- 1 -