Inventory - Grizzly G0857 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory (Figure 6–7)
A. Jointer Assembly ........................................ 1
B. Lifting Hooks .............................................. 2
C. Lock Washers 8mm (Lifting Hooks) ........... 4
D. Cap Screws M8-1.25 x 20 (Lifting Hooks) .. 4
E. Fence Tilt Handle ....................................... 1
F. Push Blocks ................................................ 2
G. Open-End Wrench 11/13mm ...................... 1
H. Open-End Wrench 8/10mm ........................ 1
I.
Hex Wrench 6mm ....................................... 1
J.
Knife-Setting Jig (G0857)
—External Retaining Rings .................... 4
—Knife Jig Feet ...................................... 2
—Knife Jig Rod ....................................... 1
K. Helical Cutterhead Accessories (G0858)
—T-Handle Torx Driver T-25 ................... 2
—Torx Screws T-25 #10-32 x
—Indexable Inserts 15 x 15 x 2.5mm ..... 5
-16-
D
Qty
⁄ ........... 10
1
2
Figure 6. Inventory—jointer assembly.
B
C E
G
H
I
J
Figure 7. Inventory—loose items.
Model G0857/G0858 (Mfd. Since 07/19)
A
F
K