Identification - Grizzly G0857 Owner's Manual

Become familiar with the names and locations of the controls and features shown below to better understand
the instructions in this manual.
Outfeed
Table
Outfeed Table
Lock
Outfeed Table
Adjustment Lever
Cutterhead
Guard
Adjustment Knob
For Your Own Safety Read Instruction Manual Before Operating Jointer
a) Wear eye protection.
b) Always keep cutterhead and drive guards in place and in proper operating condition. If
removed, ALWAYS replace cutterhead guard immediately after rabbeting operations.
c) Never make cuts deeper than
d) Always use hold-down or push blocks when jointing material narrower than 3" or planing
material thinner than 3".
e) Never perform jointing, planing, or rabbeting cuts on pieces shorter than 10" in length.
Model G0857/G0858 (Mfd. Since 07/19)

Identification

Fence Infeed Table Stop
Release Knob
Fence Tilt
Handle
Fence
Rear Access
Panel
⁄ "per pass.
1
8
Infeed Table
ON/STOP Switch
Adjustment Lever
Push Block
Holders
(2 of 4)
Mobile Base Lock Knobs
Fence Tilt Lock
Lock
Depth-of-Cut
Scale
Infeed
Table
Infeed Table
Fence Lock
Lever
4" Dust
Port
-3-