To Replace The Body Suspension Parts; To Replace The Cutting Module - Husqvarna GARDENA SILENO city Workshop Manual

7. Reassemble the upper chassis and the body
To assemble the upper chassis and
system. Refer to
the body system on page 28 .

6.12 To replace the body suspension parts

1. Lift up the body suspension parts by using a small
flat screwdriver. Pull the screwdriver gently
backwards.
2. Put the screwdriver between the suspension system
and the lower chassis. Push the screwdriver
upwards and remove the suspension part.
3. To assemble the body suspension parts, refit the pin
into the slot and refit the ring into the correct
position.
26 - Repair instructions
4. Push the body suspension part into the hole in the
lower chassis.

6.13 To replace the cutting module

1. Set the cutting height adjustment to MAX. Refer to
Operation - Adjust the cutting height in the
Operator's manual.
2. Disassemble the body system. Refer to
disassemble the body system on page 17 .
3. Disassemble the upper chassis. Refer to
disassemble the upper chassis on page 19 .
4. Loosen the 3 screws (torx 20) and pull the blade
disc up.
To
To
1067 - 001 - 16.04.2019