To Clean And Replace The Ventilation Filter; To Replace The Keypad - Husqvarna GARDENA SILENO city Workshop Manual

4. Push the 2 clips holding the battery cover and
remove it.
5. Disconnect the cable from the rear sensor board.
6. Push the 2 clips and pull up to remove the battery.
7. Connect the new original battery to the rear sensor
module and fit the new battery.
8. Put the battery cover into place and fasten with the 2
screws (torx 20).
9. Refit the rear wheel/rear wheels.
Note: When replacing the battery, the charging cycle
counter should be reset. This is done in Autocheck.
6.9.2 To replace the charging strips on the product
When the product's battery does not recharge this may
be due to worn or damaged charging strips.
The charging strips are included in the rear sensor
To replace the rear sensor module on
module. Refer to
page 22 .
1067 - 001 - 16.04.2019
Also check the contact strips on the charging station.
To replace the charging tower on page 29 .
Refer to

6.10 To clean and replace the ventilation filter

Note: The ventilation filter needs to be cleaned regularly
and must be replaced if damaged.
1. Disassemble the body. Refer to
body system on page 17 .
®
2. Only for Husqvarna
the STOP button, refer to step 3-5 in
disassemble the upper chassis on page 19 .
3. Disassemble the filter cover with a small screwdriver
and carefully push one side of the cover outwards.
4. If the filter is not damaged. Clean the filter carefully
with a clean and soft brush and move to step 8.
5. Remove the damaged filter.
6. Clean thoroughly around the mounting surfaces.
7. Apply the new filter, ensuring the adhesive surfaces
fasten properly to the chassis.
8. Refit the filter cover.
®
9. Only for Husqvarna
STOP button.
10. Reassemble the body system. Refer to
the upper chassis and the body system on page
28 .

6.11 To replace the keypad

1. Disassemble the body system. Refer to
disassemble the body system on page 17 .
2. Disassemble the upper chassis. Refer to
disassemble the upper chassis on page 19 .
3. Peel off the keypad from the chassis.
4. Clean the chassis from glue residue.
5. Remove the protective liner from the new keypad,
and press the keypad into position.
CAUTION: There must not be any loose
corners or air bubbles as this can cause dirt
and moisture to get in under the keypad.
6. Reconnect the new keypad to the HMI circuit board.
To disassemble the
®
and McCULLOCH . Remove
To
®
and McCULLOCH , refit the
To assemble
To
To
Repair instructions - 25