The Lower Chassis; The Cutting System; To Mount Screws; To Disassemble The Body System - Husqvarna GARDENA SILENO city Workshop Manual

6.3 The lower chassis

The lower chassis is structured mechanically around the
following modules:
1
4
1. Lower chassis
2. Rear housing module
3. Rear wheel / Rear wheels (only for GARDENA
SILENO life and smart SILENO life and
®
Husqvarna )
4. Front wheels
Note: There are 2 sealing strips between the upper and
lower chassis. Always replace the sealing strips when
the product is opened.

6.4 The cutting system

The cutting system is structured mechanically around
the following modules:
3
1. Cutting module
2. Guard
3. Blade disc

6.5 To mount screws

It is important to mount the screws correctly. Incorrect
mounted screws may harm the product.
1067 - 001 - 16.04.2019
2
3
®
1
2
Note: Read the section about how to mount screws in
plastic before starting any maintenance. Refer to
mount screws in plastic on page 29 .
Note: Always use the recommended torque to mount the
Screw fasteners on page 32 .
screws. Refer to

6.6 To disassemble the body system

CAUTION: Clean grass and dirt from the
product before you disassemble it.
Note: This section describes how to disassemble all
parts of the body. For service or changing of spare parts
all steps may not be needed.
1. Push the ON/OFF button to disable the product. The
product is disabled when the indicator lamp is not lit.
2.
®
a) For GARDENA
is attached to the body by clips. Pull the top
cover up clockwise by hand and remove it.
b) For McCULLOCH
2 screws into the body. Loosen the 2 screws,
(Torx 20), and remove it.
To
®
and Husqvarna the top cover
®
the top cover is attached by
Repair instructions - 17