Husqvarna GARDENA SILENO city Workshop Manual page 36

Messages
Number Message
INSTALLATION
15 Mower lifted
13 No drive
10 Upside down
50 Guide not found
56 Guide calibration ac-
complished
57 Guide calibration failed Guide wire calibration has failed.
36 - Troubleshooting
Cause
The lift sensor has been activated due
to the product getting stuck.
One of the lift senor magnets is inver-
ted or missing.
The lift sensor is faulty.
The product has got caught in some-
thing.
The working area includes a steep
slope.
The guide wire is not laid at an angle
on a slope.
The product is leaning too much, or
has turned over.
The product is no longer receiving sig-
nals from the guide wire.
Guide wire calibration has been suc-
cessful.
Action
Free the product and rectify the reason.
Check the magnet. Refer to
sors on page 7 .
Check the lift sensor. Refer to
sors on page 7 .
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Check the maximum guaranteed slope.
Steeper slopes should be isolated.
Lay the guide wire at an angle across
the slope.
Turn the product the right way up and
rectify the reason.
Check connection of guide wire to
charging station. To locate a break in a
To find a break in the
wire, refer to
boundary loop on page 42 .
No action.
Check that the guide wires are installed
according to instructions. Then carry
out a new calibration. Refer to
Calibrate on page 12 .
1067 - 001 - 16.04.2019
Lift sen-
Lift sen-
Tools -