To Clean And Replace The Ventilation Filter; To Replace The Body Suspension Parts; To Replace The Keypad - Husqvarna GARDENA SILENO MINIMO Workshop Manual

Also check the contact plates on the charging station.
To replace the charging tower on page 20 .
Refer to

5.12 To clean and replace the ventilation filter

Note: The ventilation filter needs to be cleaned regularly
and must be replaced if damaged.
1. Remove the body. Refer to
the body system on page 13 .
2. Remove the STOP button. Refer to
install the STOP button on page 15 .
3. If the filter is not damaged. Clean the filter carefully
with a clean and soft brush and move to step 7.
4. Remove the damaged filter.
5. Clean thoroughly around the mounting surfaces.
6. Apply the new filter, ensuring the adhesive surfaces
fasten properly to the chassis.
7. Install in the opposite sequence.
18 - Repair instructions
To remove and install
To remove and

5.13 To replace the body suspension parts

1. Lift up the body suspension parts by using a small
flat screwdriver. Pull the screwdriver gently
backwards.
2. Put the screwdriver between the suspension system
and the lower chassis. Push the screwdriver
upwards and remove the suspension part.
3. To assemble the body suspension parts, install the
pin into the slot and install the ring into the correct
position.
4. Push the body suspension part into the hole in the
lower chassis.
5. Install in the opposite sequence.

5.14 To replace the keypad

1. Remove the lower chassis. Refer to
install the lower chassis on page 14 .
2. Disconnect the cable to the main circuit board.
3. Remove the keypad from upper chassis.
Note: The keypad is glued to the upper chassis.
4. Clean the chassis from glue residue.
5. Remove the protective liner from the new keypad,
and press the keypad into position.
To remove and
1595 - 001 - 01.02.2021