Safety Notes; Environmental Protection And Recycling; Transportation And Packaging - REMKO KWK Series Operation,Technology,Spare Parts

REMKO KWK / KWK-ZW

Safety notes

Carefully read the operating manual
before placing the unit in service
for the first time. It contains
useful tips and notes as well
as hazard warnings to prevent injury
to persons or material damage
Failure to follow the directions
in this manual can endanger
persons, the environment and
the equipment itself and will void
any claims for liability.
Keep this manual close to
■
the units.
The units and components
■
should not be exposed to any
mechanical load, and extreme
levels of humidity or sunlight.
Only qualified personnel may
■
set up and install the units
and components.
The set-up, connection, and
■
operation of the unit and its
components must take place
in accordance with the operating
conditions stipulated in this
manual and comply with all
applicable local regulations.
Mobile units must be set up
■
securely on suitable surfaces and
in an upright position. Stationary
units must be permanently
installed for operation.
Modification of the units
■
and components supplied by
REMKO is not permitted and
can cause malfunctions.
Units and components may
■
not be operated in areas where
there is an increased risk of
damage. Observe the minimum
clearances.
The electrical power supply is to
■
be adapted to the requirements
of the units.
4
The operational safety
■
of the units and components
is only assured if they are
fully assembled and used as
intended. Safety devices may
not be modified or bypassed.
.
Do not operate units or
■
components with obvious
defects or signs of damage.
All housing parts and unit
■
openings, e.g. air inlets and
outlets, must be free from
foreign objects, liquids, or gases.
The units and components must
■
be kept at an adequate distance
from flammable, explosive,
combustible, abrasive and dirty
areas or atmospheres.
Contact with some parts
■
of the unit or components can
result in burns or other injuries.
Wearing appropriate protective
clothing is necessary to avert
risks.
Only authorised and trained
■
persons are permitted to access
and operate the units and
components.
Installation, repair and
■
maintenance work may only
be carried out by authorised
specialists. Visual inspections
and cleaning can be performed
by the operator as long
as the unit is disconnected from
the power.
To preclude any risks to persons
■
originating from the units,
appropriate precautions must
be taken when installing,
repairing, maintaining, cleaning
or working on the units.
Environmental
protection and recycling
Disposal of packaging
All products are packed for
transport in environmentally
friendly materials. Make a valuable
contribution to reducing waste
and sustaining raw materials. Only
dispose of packaging at approved
collection points.
Disposing of the units
and their components
Only recyclable materials are used
to manufacture the units and
components.
Help protect the environment
by ensuring that the units
or components (for example
batteries) are not disposed
of in household waste, but
only in accordance with
local regulations and in
an environmentally safe manner,
e.g. using authorised disposal and
recycling specialists or council
collection points.
Transportation
and packaging
The units are shipped in sturdy
transport packaging. Immediately
check the units on delivery and
make a note of any damage or
missing parts on the delivery note.
Inform the forwarding agent and
contractual partner.
Claims under guarantee made at
a later date will not be accepted.