Installation - REMKO KWK Series Operation,Technology,Spare Parts

REMKO KWK / KWK-ZW
Air outlet
The unit can be used with
■
a duct elbow of 90° (accessory).
A grille optically hides
the opening.
The unit can be used with
■
a customer-supplied duct
connection piece with
a maximum length of 300 mm.
In order to decouple
■
the vibrations, a flexible duct
piece, e.g. canvas connection
piece, should be provided.
Duct elbow, 90°, air inlet
Duct elbow, 90°, air outlet
NOTE
The air ducting must then be
selected in such a way that no short-
circuit can occur on the air side.
NOTE
If the unit is not mounted
positively, vibration can occur.
14

Installation

Unit installation
Wall installation
The unit is attached by means
of mounting holes in the case while
also taking account of the air outlet
side located in the upper part
of the unit.
Mark the mounting points
■
according to the bracket's
dimensions on structurally
acceptable building
components and secure
the unit.
Check again that the unit
■
is level.
Connect the medium pipes,
■
electrical cables and condensate
drainage line to the unit
as described below.
Unit suspension
D
View from the front
A
KWK 100-140 659
KWK 200-220 809
KWK 280-300 959
KWK 360-420 1109
KWK 590-680 1409
KWK 740-870 1709
NOTE
Installation should only
be performed by authorised
specialists.
Ceiling installation
The unit is attached by means
of mounting holes in the case while
also taking account of the air outlet
side directed towards the centre
of the room.
Mark the mounting points
■
according to the bracket's
dimensions on structurally
acceptable building
components and secure
the unit.
Check again that the unit
■
is level.
Connect the medium pipes,
■
electrical cables and condensate
drainage line to the unit
as described below.
A
B
B C D
415 88 156
545 88 156
715 88 156
865 88 156
1165 88 156
1465 88 156
G
F
E
C
All measurements in mm
E F G
65 210 70
65 210 70
65 210 70
65 210 70
65 210 95
65 210 95