Enabling Call Transfer; Disconnecting A Call - TANDBERG Gatekeeper User Manual
Tandberg gatekeeper user guide
Hide thumbs
Also See for Gatekeeper:
- Installation instructions (1 page) ,
- User manual (59 pages) ,
- User manual (101 pages)
Table of Contents
Advertisement
TANDBERG Gatekeeper User Guide
12.3.2.
Enabling call transfer
To enable call transfer, either:
issue the command:
xConfiguration Services CallTransfer Mode: <On/Off>
or go to
Gatekeeper Configuration
->
Services
and in the
Call Transfer
section, tick the
Allow call transfer
box (see Figure 23).
Figure 23: Enabling call transfer
12.4.
Disconnecting a Call
An existing call may be disconnected using the Gatekeeper by issuing the command:
xCommand DisconnectCall: <index>
where:
the call index as reported by xStatus Calls
index
Page 52 of 105
Advertisement
Table of Contents
