Installation; Precautions; Preparing The Installation Site - TANDBERG Gatekeeper User Manual

3.

Installation

3.1.

Precautions


Never install communication equipment during a lightning storm.

Never install jacks for communication cables in wet locations unless the jack is specifically
designed for wet locations.

Never touch uninstalled communication wires or terminals unless the communication line has
been disconnected at the network interface.

Use caution when installing or modifying communication lines.

Avoid using communication equipment (other than a cordless type) during an electrical storm.

There may be a remote risk of electrical shock from lightning.

Do not use communication equipment to report a gas leak in the vicinity of the leak.

The socket outlet shall be installed near to the equipment and shall be easily accessible.

Never install cables without first switching the power OFF.

This product complies with directives: LVD 73/23/EC and EMC 89/366/EEC.

Power must be switched off before power supplies can be removed from or installed into the
unit.
3.2.

Preparing the Installation Site


Make sure that the Gatekeeper is accessible and that all cables can be easily connected.

For ventilation: Leave a space of at least 10cm (4 inches) behind the Gatekeeper's rear and 5cm
(2 inches) on the sides.

The room in which you install the Gatekeeper should have an ambient temperature between 0C
and 35C (32F and 95F) and between 10% and 90% non-condensing relative humidity.

Do not place hot objects directly on top of or directly beneath the Gatekeeper.

Use a grounded AC power outlet for the Gatekeeper.
TANDBERG Gatekeeper User Guide
Page 14 of 105