Welch Allyn KleenSpec 790 Series Directions For Use Manual page 13

Directions for use
Troubleshooting
If you try these suggestions and still have problems, contact
Welch Allyn.
Problem
LED does not light.
LED does not light when the
auxiliary power cord is
attached.
LED does not automatically
turn off when removing the
illuminator from the
speculum.
Illuminator does not charge
in the charging base.
Contacts
For information about any Welch Allyn product, call the nearest
Welch Allyn representative:
USA
Canada
European Call Center + 353 46 906 7790
Germany
Latin America
Singapore
United Kingdom
Cordless illumination system
Probable causes & solutions
Battery is low. Charge the illuminator.
Illuminator is not seated correctly in speculum. Insert
illuminator fully into speculum.
Auxiliary power cord is not plugged in. Plug the
auxiliary power cord into an AC outlet.
Auxiliary power cord is not seated properly. Plug the
cord into the illuminator properly.
Power switch is damaged or blocked. Clean the switch
area. If the problem continues, replace the illuminator.
Charging base is not plugged in. Connect charging
base to AC power.
Illuminator is not seated properly in charging base.
Reinsert the illuminator into the charging base, and
verify that the status indicator glows amber.
1 800 535 6663 Australia
+ 1 315 685 4560
1 800 561 8797 China
France
+ 49 747 792 7186 Japan
+ 1 305 669 9003 Netherlands
+ 656 419 8100 South Africa
+ 44 207 365 6780 Sweden
11
+ 6129 638 3000
+ 86 216 327 9631
+ 3315 569 5849
+81 42 703 6084
+ 31 202 061 360
+ 2711 777 7555
+ 46 85 853 6551