Screen Adjustment - Da-Lite ADVANTAGE DELUXE ELECTROL Instruction Book

Hide thumbs Also See for ADVANTAGE DELUXE ELECTROL:

Instruction book (12 pages)

Specification (2 pages)

Specification data (2 pages)

Table of Contents

SCREEN AND ROLLER ASSEMBLY INSTALLATION

If your screen was shipped with the motor and roller already installed proceed to step 6.

1. Remove the screw from each end of the access door (front door) and open the door. See figure 1.

2. Carefully unpack screen and roller assembly. Leave packing paper on the roller.

3. Place the roller assembly into the case with the motor on the left side. The limit switches should be facing down.

Line up the square pin on the motor with the square hole in the bracket.

4. Lift the pin end (right end) of the roller into position and slide the bracket onto the roller pin. Tighten two nuts to

secure the bracket.

5. Complete electrical hook-up by snapping motor wire connector into case connector.

▲

CAUTION! DO NOT CUT TAPE ON FABRIC WITH A KNIFE OR ANY SHARP TOOL. REMOVE BY HAND.

6. Carefully remove tape strips securing picture surface around roller. Slat should move freely (Fig. 2). (Only if the

roller assembly is preinstalled.)

7. Test installation by operating the screen several times. Be prepared to stop the screen. The fabric door (rear door)

will not close until the wall switch is placed in the up position and when the screen motor stops at its limit switch

in the up direction.

NOTE: Excessive continuous operation may cause the motor to overheat. If this happens the motor will shut off until it cools to

a normal operating temperature.

8. Run the screen down enough to open the fabric door. Close the access door and reinstall the screws to secure the

door.

SCREEN MOTOR

LIMIT SWITCH

ADJUSTMENT

KNOBS

DOOR

MICROSWITCH

DOOR MOTOR