General Use - TANDBERG 1500 MXP User Manual

3 General Use

Wake up the system
When the system is not in use, it is in standby mode and the screen is black. Wake up the
system by picking up the remote control. An incoming call or pressing any key on the remote
will also wake up the system.
If the system does not respond:
 Make sure that the system is switched on by using the On/Off switch located at the
rear of the Codec.
 Verify that your monitor is switched on. To switch the monitor on, push the power
button on the front of the monitor (the button on the far right).
16