General Use; Start-Up Screen - TANDBERG Videoconferencing System Short User Manual

General use

Your system should be in standby mode. When in standby mode, pressing any key or picking up the remote
control will wake up the system. An incoming call will also wake up the system. If the system does not respond,
make sure the system is switched on.
The system's most commonly used functions are accessible directly from the remote control.
Quick keys
The three buttons on top of the remote control refer to the blocks at the bottom of the
screen. The text inside the blocks will change depending on which menu is selected.
The three Quick keys have different colors.
Preset keys
Activate pre-stored camera positions.
Video source keys
Activate connected video sources.
Camera control and menu navigation keys
Frequently used keys allowing you to control your own camera and the far end camera,
control your volume, select and move self-view, switch your microphone off and navigate
in the menu system.
Dialing keys / Preset keys
Used to make a call. The twelve number keys, (0-9), #, * operate in the same way as
on a modern push-button telephone. These buttons are also used when entering a name
into a text field.

Start-up screen

After a user-definable boot-up logo is shown, the following start-up screen is shown. This screen should provide
you with the most important system information.
TANDBERG Videoconferencing System
3
General use