Instructions for use PHYSIO Evo/Evo F/One
4 Installation | 4.2 Assembly of operator stool PHYSIO Evo/Evo F/One
4.2.4 Adjust the gas pressure spring
Note
The pressure point of the gas pressure spring is set at the factory. If the seat height
of the operator stool PHYSIO Evo/Evo F/One cannot be adjusted securely, the
pressure point of the gas pressure spring must be adapted.
See also:
2 6.1.1 Adjusting the seat height, Page 30
▶ Incline the seat forwards and remove the upholstery.
▶ Adjust the pressure point as described below using a Phillips screwdriver:
Screw in the screw, the gas pressure spring is unlocked earlier.
Loosen the screw, the gas pressure spring is unlocked later.
▶ Remount the seat upholstery.
20 / 38