Fxs/Did Small Module - Avaya Advanced Gateway 2330 Installation Manual

Port
Table 4: Module LEDs
LED
STAT
LINK/STAT 1
LINK/STAT 2

FXS/DID Small Module

The 2- and 4-port FXS/DID Small Modules are hot swappable modules.
If you are working with 2- or 4-port FXS/DID or FXO/CAMA Small Modules, ensure you read
the safety messages related to the FXS/DID and FXO/CAMA interface modules. See
Exchange Station/Direct Inward Dial (FXS/DID) Interface Modules
Exchange Office/Centralized Automatic Message Accounting (FXO/CAMA) Interface
Modules on page 8.
The FXS/DID Small Modules support only voice TDM connections. The FXS/DID Small
Modules provide voice interface access through each of the FXS/DID ports. The FXS/DID
Small Module represents the Central Office (CO) side of a telephony interface.
You can install the 2- and 4-port FXS/DID Small Modules in any of the Small Module slots
on the AG2330 chassis.
The following figure shows the 2-port FXS/DID Small Module.
Installation — Hardware Components
Connector Recommended
cable type
unloaded CAT-3
loops
General module status:
• Off: No power available to the module
• Yellow: Out of service, or failed to initiate
• Green: Power on and the module is operational.
Status of interface 1:
• Off: Not connected or the interface is out of service.
• Yellow: The interface is in a loopback mode or is running diagnostics
• Green: The link or channel is active and receiving a valid signal
Status of interface 1:
• Off: Not connected or the interface is out of service.
• Yellow: The interface is in a loopback mode or is running diagnostics
• Green: The link or channel is active and receiving a valid signal
Interface modules for the AG2330
Minimum cable
length
Description
on page 7 and
Maximum cable
length
Foreign
Foreign
August 2010 19