Removing The Ag2330 Top Cover - Avaya Advanced Gateway 2330 Installation Manual

Procedure steps
1. Insert the male RJ-45 connector in the console port of the AG2330.
2. Connect the female DB-9 to RJ-45 adapter to the opposite end of the console cable,
3. Insert the RJ-45 or female DB-9 connector (dependent on your equipment) in a

Removing the AG2330 top cover

Use the instructions in this procedure to remove the AG2330 top cover.
Prerequisites
• Ensure you have a Phillips #1 screwdriver.
• Ensure the AG2330 is powered off.
Procedure steps
1. Remove the three screws securing the left-hand side bracket to the chassis and the
Installation — Hardware Components
if necessary.
terminal or PC.
top cover.
See the following figure for reference.
Removing the AG2330 top cover
August 2010 33