Polytron PolySelect TSM 1000 HD User Manual

Polytron PolySelect TSM 1000 HD User Manual

Sat-if channel processing unit

Advertisement

SAT-ZF Kanalaufbereitung
SAT-IF Channel processing unit
PolySelect TSM 1000 HD
Bedienungsanleitung/
User manual
0901467 V1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PolySelect TSM 1000 HD and is the answer not in the manual?

Questions and answers

Summary of Contents for Polytron PolySelect TSM 1000 HD

  • Page 1 SAT-ZF Kanalaufbereitung SAT-IF Channel processing unit PolySelect TSM 1000 HD Bedienungsanleitung/ User manual 0901467 V1...
  • Page 2 Sicherheitsvorkehrungen Safety precautions Vor dem Arbeiten am Grundgerät TSM 1000 bitte Before working on the base unit TSM 1000 please unbedingt folgende Sicherheitsbestimmungen sorg- read the following safety precautions carefully! fältig lesen! ACHTUNG Das Öffnen des Gerätes sollte nur von au- ATTENTION The unit should only be opened by torisiertem Fachpersonal durchgeführt werden.
  • Page 3: Table Of Contents

    The editor is grateful for lers führen. Für Verbesserungsvorschläge ist der Ver- suggestions. fasser dankbar. Verfasser: Editor: Polytron-Vertrieb GmbH Polytron-Vertrieb GmbH Postfach 10 02 33 Postfach 10 02 33 75313 Bad Wildbad 75313 Bad Wildbad...
  • Page 4: Beschreibung/ Description

    1 Beschreibung 1 Description Bei der TSM 1000 HD wird jeder The TSM 1000 HD converts all gewünschte analoge oder digitale required analogue digital SAT-Transponder aus seiner ur- SAT-transponders from their orig- sprünglichen Frequenzlage in ein inal frequency position to a frei wählbares Frequenzraster um- freely selectable frequency ras- gesetzt.
  • Page 5: Vorbereitungen/ Preparations

    2 Vorbereitungen 2 Preparations Die insgesamt vier Kreuzschlitzschrauben (Bild Loosen the in total four cross-head screws 3/1) oben und unten am Gehäuseoberteil lösen (Figure 3/1) on the top and the bottom of the und dieses vorsichtig abnehmen. housing upper part and remove it carefully. Auf die Eingänge (Bild 3/2, vordere Reihe) The desired satellite signal is switched on the werden die gewünschten Satellitensignale ge-...
  • Page 6: Bedienung/ Operation

    3 Bedienung 3 Operation 3.1 Programmierung 3.1. Programming Vor Beginn der Programmierung sollte über- First of all it is necessary to check where a free prüft werden, wo sich im SAT-ZF-Bereich noch place for the required transponder within the genügend Platz für den gewünschten SAT- SAT-range is available before programming.
  • Page 7: Programmierablauf / Programming Procedure

    3.2 Programmierablauf / Programming procedure see next page Das Gerät geht nach 1,5 Minuten automatisch auf standby.
  • Page 8: Einpegelung/ Level Adjustment

    3.3 Einpegelung 3.3 Level adjustment Nachdem die Kanäle programmiert wurden, The plant has to be adjusted after the channels muss die Anlage eingepegelt werden. were programmed. Vorgehensweise beim Einpegeln der TSM- Procedure while levelling out the TSM 1000 1000 HD: 1) Pegelsteller (Bild 4 Seite 11 Position 9) für 1) Adjust attenuator (Figure 4 page 11 position Gesamtpegel auf mittlere Position stellen.
  • Page 9: Funktionen Im Service-Menü/ Functions Of Service Menue

    3.5 Funktionen im Service-Menü 3.5 Functions of the service menu 3.5.1 Restoration of basic setting 3.5.1 Wiederherstellung der Grundeinstel- When in Standby mode (●), push the buttons lung OK, + and – at the same time until the dot dis- Im Standby-Modus (●) drücken Sie die Tasten appears.
  • Page 10: Bauteile Des Tsm 1000 Hd / Components Of The Tsm 1000 Hd

    Bauteile des TSM 1000 / Components of the TSM 1000 12 11 1 SAT-Signaleingang (Kanal 1) 8 LED-Anzeige (vordere Reihe) LED-Display SAT-Signal input (Channel 1) 9 Gesamtpegelsteller (front row) total level controller 2 Durchschleifausgang 10 + (Plustaste) (hintere Reihe) + (Plus button) Feed-through output 11 −...
  • Page 11: Technische Daten/ Technical Data

    5 Technische Daten/ Technical Data 5.1 Eingangsbereich / Input Eingangsfrequenz/ Input frequency range ........950 ... 2150 MHz Eingangspegel/ Input level ..............52 ... 75 dBµV Frequenzabstimmung/ Frequency Stepps ........ 1 MHz Schritte/steps LNB-Speisung/ LNB feeding voltage .........................12 V= / 250 mA pro Eingang/max. gesamt 500 mA ..........
  • Page 12 + 49 (0) 70 81/1702 - 0 Technische Hotline Technical hotline + 49 (0) 70 81/1702 - 12 Telefax + 49 (0) 70 81) 1702 - 50 Internet http://www.polytron.de eMail info@polytron.de Technische Änderungen vorbehalten Subject to change without prior notice Copyright © Polytron-Vertrieb GmbH...

Table of Contents