Functional Overview; Front Panel; Rear Panel - Symphonic CHSP80G Owner's Manual

Front Panel

1 2
POWER
DVR
16

Rear Panel

1 POWER indicator: Lights up when the power is on.
2 DVR indicator: Lights up when DVR mode is selected.
3 DVD indicator: Lights up when DVD mode is
selected.
4 I REC / OTR : Press once to start a basic recording.
Press repeatedly to start an OTR (One Touch
Recording). Each press increases the recording time by
30 minutes up to eight hours.
5 F PAUSE : Press to pause playback or recording.
6 C STOP : Press to stop playback or recording.
7 B PLAY * : Press to start or resume playback. Press and
hold for 5 seconds to set the Progressive Scan mode on /
off. (DVD mode only)
8 Remote control sensor: Receives signals from the
remote control.
9 Display: Shows information and messages.
10 A OPEN / CLOSE * : Press to open / close the disc
tray.
11 Disc tray: Place a DVD here.
12 D/ G (SKIP/FWD) : During playback, press to skip to
the next title, chapter, or track. During playback, press and
hold for 2 seconds for fast forward. When playback is
paused, press and hold for 2 seconds for slow forward
and press repeatedly for step by step playback.
13 H /E (SKIP/REV) : During playback, press to skip
to the previous title, chapter, or track
During playback,press and hold for 2 seconds for fast reverse.
When playback is paused, press and hold for 2 seconds for slow
reverse and press repeatedly for step by step playback.
14 CHANNEL K / L: Press to change the channel.
15 Device select button : Press to switch the device
mode between DVR and DVD.
16 POWER: Press to turn the unit on / off. The red LED
is lit when the power is on.
10 EN
Before You Start

Functional Overview

3 4 5 6 7*
REC/OTR PAUSE STOP PLAY
DVD
CHANNEL
15 14 13 12
17
* The unit can also be turned on by pressing these buttons.
8 9 10*
OPEN/CLOSE
18
DIGITAL AUDIO OUTPUT
PCM/BITSTREAM
COAXIAL
17 AC Power Cord: Connect to a standard AC outlet to
supply power to this unit.
18 COAXIAL DIGITAL AUDIO OUT: Connect an AV
receiver, Dolby Digital decoder or other equipment
with a coaxial digital input jack with an audio coaxial
digital cable.
19 VIDEO OUT: Connect the video input of a TV
monitor, AV receiver, or other equipment here using
the supplied video cable.
20 COMPONENT VIDEO OUT: Connect the
component video input of a TV monitor, AV receiver,
or other equipment here using a commercially available
component video cable. (DVD mode only)
21 S-VIDEO OUT: Connect the S-Video input of a TV
monitor, AV receiver, or other equipment here using a
commercially available S-Video cable.
22 VIDEO IN(LINE1) : Connect the video output of an
external device here using the supplied video cable.
23 TV ANTENNA IN: Use to connect an antenna.
24 TV ANTENNA OUT: Use to connect an antenna
cable to pass the signal from the TV ANTENNA IN to
your TV monitor.
25 AUDIO IN(LINE1) : Connect an external equipment
here using a supplied audio cables.
26 AUDIO OUT : Connect the audio input of a TV
monitor, AV receiver, or other equipment here using
the supplied audio (L / R) cables.
Note: Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
11
19 20 21 22 23 24
COMPONENT
VIDEO OUT
VIDEO IN
Y VIDEO OUTPUT
S-VIDEO
L L P /
B
C
B
L
R
P /
R
R R
2 1 C
R
AUDIO IN
OUT
AUDIO OUT
26 25
IN
OUT
ANTENNA