Intersection Equipment Installation Instructions
1.4.3 Electric Shock
The possibility of electrical shock exists when installing intersection equipment, since connections must be
made to open terminals within the traffic control cabinet which may have 120 VAC present. Follow proper
work procedures and read and understand the safety messages in this manual.
As a trained installer of electrical equipment you are aware of the dangers associated with installation of
electrical devices. Always be sure that the power to the equipment, and all associated equipment, is turned
off before beginning any procedure. Use the equipment, techniques, and procedures that you learned
during your training or apprenticeship or other electrical industry recognized safety procedures.
If you are unsure of which techniques, procedures, and protective equipment are recommended or
appropriate for the job, ask your supervisor or foreman.
1.5 Disposal of Device
Please dispose of the device in accordance with all local, state, and federal laws and regulations.
1.6 FCC Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interferences when the equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. If operation of this
equipment in a residential area causes harmful interference, the user is required to correct the interference
at their own expense.
*The method of using the components of the Opticom GPS system may be covered by one or more of US Patent
Numbers 5539398, 5926113, 5986575, 6243026.
Figure 1-1 FCC label Locations
6