Radio Mounting; Radio/Gps Unit Cable Terminations - OPTICOM 764 Installation Manual

3.1.2.2 Radio mounting

The Model 1012 radio may be placed on a shelf in the cabinet or it may be mounted using the included
self-tapping screws.

3.1.2.3 Radio/GPS Unit Cable Terminations

1. Route the cables from the radio/GPS antenna through the cabinet to the radio/GPS unit location. Coil up
any excess cable.
NOTE:
•
When coiling excess cable do not create any sharp bends in the cable or the cable may be
damaged.
2. Connect the cable labeled GPS to the GPS connector on the radio/GPS unit. Connect the other cable to
the Radio connector. Tighten the connectors using a 5/16 inch wrench (an 8 mm wrench may also be
used).
3. Plug the 15 pin connector of the radio/GPS cable (black cable) into the P1 connector of the radio/GPS
unit and tighten the screws.
4. Route the cable to the location where the phase selector will be installed.
5. Skip to Section 5.5.2 for details on connecting the radio/GPS cable.
NOTES:
•
The connectors are keyed and cannot be connected to the wrong connector.
•
To avoid damage to the equipment always connect the GPS and Radio connectors before
connecting the radio/GPS cable. Plug the cable into the phase selector last.
•
The radio/GPS unit is not watertight; therefore it must be mounted inside the cabinet
compartment.
•
Never operate the equipment with the antenna cables disconnected or the equipment may be
damaged.
Intersection Equipment Installation Instructions
Figure 3-8. Mounting Model 1012 Radio/GPS Unit
18