Communication Ports; Ethernet Port; Ethernet Indicators - OPTICOM 764 Installation Manual

12 Communication Ports

Phase selectors have multiple communication ports:
•
One Ethernet port
•
One USB port
•
Four RS-232 ports

12.1 Ethernet Port

The default address for the Ethernet port is:
•
The address and port numbers in the phase selector may be changed using the On-site or CMS
software. See the On-site and CMS help files for details.
o Record the new address and port numbers so that you can communicate with the phase
selector.
o It is possible to reset the IP settings, see section 13-2 for details.
•
Connect a standard Ethernet cable between the Ethernet port on the phase selector and the Ethernet
network device that you will use to communicate with the phase selector.

12.1.1 Ethernet indicators

There are two indicator lights on the Ethernet port. The following is the meaning of these indicators:
Indicator Off
Yellow No Ethernet connection
Green Speed set to 10Mb/s
Intersection Equipment Installation Instructions
IP Address
TCP Port
UDP Port
Table 12-1 Ethernet Port Default settings
Pin
1
2
3
4
5
6
7 Signal Common (0V) for data 1
8 Signal Common (0V) for data 1
Table 12-2 Ethernet port pin assignment
Table 12-3 Ethernet port indicator meaning
192.168.0.1
5000
6000
Function
Data 1+
Data 1 -
Data 2 +
Not used
Not Used
Data 2 -
Solid
Ethernet port connected
Speed set to 100Mb/s
46
Flashing
Active communication
n/a